Whether the awning must be removed depends to a large extent on the geographical environment (traffic density, air pollution, environmental pollution, etc.). Be sure to remove the following requirements: If there is a small stain on the cloth, use a soft brush dipped in general detergent to brush lightly, and then use cold water to clean it several times until there is residual detergent on the cotton fabric, open it to dry. When the RV awning is dry, use a soft brush to remove dust on time. Similar items such as tree skills and dead leaves should be eliminated immediately. The awning can only be shrunk after it is clean and tidy and dried. When a wet awning has to shrink, remember to fully unfold and dry it whenever you get the chance.

For prefabricated components made of high-end aluminum profiles on outdoor awnings, pH (such as hydrogen chloride) or polishing materials (such as abrasive pads, gold steel sandpaper, sandpaper, spar, etc.) cannot be used, as they can damage the surface. When removing the canopy, it should be fully opened and removed when it is dry. Use proper procedures for Windshield Shades factory cleaning and maintenance without leaning against the RV awning or pressing too hard on it. The outdoor awning with automatic controller is carrying out all operation procedures, please cut off the switching power supply circuit as much as possible, and turn off the mechanical automation equipment. The removal of 　Window UV proof Car Sunshade factory the aluminum profile frame should be treated with extra care, generally using elastic cloth and detergent. And note that the cleaning agent used on high-grade aluminum profiles should not go beyond the cloth of the sunshade canopy.